Black Cat Boat Tent Airframe 338x220x110CM

The further processing of the innovative Black Cat Boat Cave 2.0 is mainly characterized by a completely new, extremely strong and at the same time resilient supporting trusses made of inflatable high-pressure hoses. The construction with the hoses is in the form of a cross vault with additional reinforcements along the length up to the tip of the boat and therefore provides extreme stability during sailing, in hard and stormy conditions. Furthermore, the outer skin lying in the water, which can withstand a water column of 5000 millimeters, is completely free from the construction with the hoses. While the inner tent against condensation water is attached to the hoses on the inside,. As a result, the space in the boat is expanded to a maximum, while the tent size remains the same. Transparent windows were fitted along both long sides, which can be covered from the outside with an additional cover of tent fabric. Both clear windows are protected by an awning spread by fiberglass rods. This awning reliably transports rainwater away from the windows. The entrance door, which is divided in the middle, was additionally equipped with a panic lock, so that you could quickly get out of the tent even in an emergency. On the inside of the door the width of the bottom are again the tried and tested Velcro bags, in which you can place lead weights in the correct weight to minimize the door flapping in the wind. Large clear windows at the entrance allow a good view of the rod tips. Depending on the weather conditions, the transparent windows can also be replaced by windows with mosquito netting. The bow opening was equipped with a complete continuous Velcro closure, so that the front part is better protected against rainwater. Here too, a transparent window has been installed, which can be darkened from the outside. The forward bow section is well protected above by a protruding canopy and allows an unobstructed view to the front. The already proven awning in the rear of the boat has been adapted to the inflatable construction with a fiberglass rod, similar to the windows, which can be rolled up when not in use and attached to the main tent with Velcro. Due to the dimensions of 3.40 meters long and 2 meters wide in the middle, the Boat Cave 3.0 can be used on almost all common types of fishing boats. The many individual fixing points in the form of D-rings allow flexible and secure attachment to the boat wall. The optimal width to use is 200 centimeters.